Circuit board cleaning agent
KD-285 circuit board cleaning agent is a cost-effective cleaning agent independently developed and produced by our company. It is formulated with imported high-purity raw materials through a special formula. This product can quickly remove rosin, flux, oil, solder paste, dust, prints and other impurities on electronic circuit boards and capacitor equipment, and can meet the requirements of brushing, dipping, ultrasonic cleaning and spray cleaning.
Circuit Board Cleaner
KD-285 circuit board cleaning agent is a cost-effective cleaning agent independently developed and produced by our company. It is formulated with imported high-purity raw materials through a special formula. This product can quickly remove rosin, flux, oil, solder paste, dust, prints and other impurities on electronic circuit boards and capacitor equipment, and can meet the requirements of brushing, dipping, ultrasonic cleaning and spray cleaning.
KD-285 circuit board cleaning agent is a cost-effective cleaning agent independently developed and produced by our company. It is formulated with imported high-purity raw materials through a special formula. This product can quickly remove rosin, flux, oil, solder paste, dust, prints and other impurities on electronic circuit boards and capacitor equipment, and can meet the requirements of brushing, dipping, ultrasonic cleaning and spray cleaning. It does not contain controlled substances such as heavy metals, phosphorus, and nitrite, and has no corrosion on the surface of the workpiece.
1. It has strong decontamination power and can quickly remove residues from circuit boards.
2. No corrosion. This product has no corrosion to steel, iron, copper, aluminum, stainless steel and other metals.
3. No flash point, safe and non-destructive to components.
4. It can evaporate quickly and completely without any residue, saving man-hours.
5. It is easy to use, the equipment required is low-priced, and there are few supporting cleaning equipment.
Scope of application
It is widely used in the electronics industry to clean flux residue after soldering circuit boards, printed circuit boards and electronic components.
Instructions
Room temperature immersion cleaning or ultrasonic cleaning
Precautions
1. Avoid open flames at the operation site and maintain ventilation at the cleaning site.
2. Be careful not to splash into your eyes during use. If it accidentally splashes into your eyes, rinse immediately with clean water.
3. Please wear chemical-resistant gloves when operating
4. When not in use, please store it in a place below 40 ℃ to avoid sun exposure.
